![]() Any movement outside of these bounds, or inside the clamp area, will be rejected. G-code must be absolutely positioned inside of the machine, and not exceed the work area and Smart Clamp Area.Comments in parenthesis or lines ending in ( ) will be ignored.There is no need to include those commands. All settings commands with only one option (G54, G17, G90, etc.) are the default.Tool changes are not allowed, so no more than one tool can be written to a file at a time.Only linear movements are allowed (arcs must be linearized).ALWAYS include a G20 or G21 depending on your coordinate system to avoid confusion.The following commands are allowed, in this order, followed by a decimal (or whole) number The following commands are allowed exactly as shown ![]() ![]() The range of allowed options is currently small because we want to be sure that any g-code that is sent is correctly parsed, visualized and safely executed by the machine.Īny g-code commands not listed here will cause Easel to reject the entire file. This document describes the format of g-code files that can be sent by Easel. : Add note to always include unit system (G20/G21), Published
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |